Abaqus attachment points. . When needing to define a number of connection points along a line, the “create attachment points along direction” option can be used to avoid specifying each point individually. Abaqus/CAE displays the Create Attachment Points Along Direction dialog box. If desired, toggle off At start point and/or At end point to prevent Abaqus/CAE from creating the additional points. If you are in the Part module or Property module, click Done in the prompt area to indicate that you have finished selecting attachment points to remove. This tool allows you to create attachment points by defining a line and specifying the number of points along the line or specifying the spacing of the points along the line. Choose the start point and end point of a projection vector. You can click Sets from the right side of the prompt area to remove a previously defined set. From the current viewport, select the attachment points or lines to remove. Each layer connects two fastening points using either a connector element or a BEAMMPC. 9eyg u2qlh 9fg3g uokz wjg 3z h374h7 fdk rv 6mfo